Würth PRO600 FCLIP3D front locking clips

Description

Würth PRO600-FCLIP3D 3D adjustable front locking clips connect the drawer box to PRO600 undermount slides, with height, depth, and tilt adjustment so the drawer front lines up perfectly. One left and one right are required per drawer. Sold per pair.

Helpful guides

• Drawer boxes for Blum undermount slides: 563 Tandem and Movento
• How to install undermount drawer slides
• How to adjust undermount soft close drawer slides

Need the drawer box too? Build a custom drawer box or get an instant quote.

What a front locking device does

Würth makes this front locking device for Würth PRO600 and PRO600 HD runners. It is the small moving part at the front corner of the box: press it on, lower the box onto the runners, and it clicks home and holds the front at whatever height, side, and depth setting the adjusters are turned to. Sold as a left and right pair, which completes one drawer.

What it fits

Match the device to the runner stamp, not just the brand: part PRO600-FCLIP3D is for Würth PRO600 and PRO600 HD runners. It adjusts height, side, and depth (in and out) adjustment. Tilt correction is not part of part PRO600-FCLIP3D.

When to use this one

Where part PRO600-FCLIP3D earns its place: most PRO600 drawers; it is the clip that ships with the runner and the one we stock as spares. It works in face frame and frameless cabinets alike, because the cabinet side of the job is handled by the runner and its rear bracket, not the clip.

Installing and adjusting it

Press part PRO600-FCLIP3D into its pre bored holes before the box goes on the runners, not after; it clicks into place and then the box lowers onto the runner hooks and the extended device locks down. How to install undermount drawer slides covers that sequence for part PRO600-FCLIP3D, and How to adjust undermount soft close drawer slides covers the height, side to side, and depth adjusters once the drawer is hanging. The pre bore itself is part of our free notch and drill prep, so part PRO600-FCLIP3D presses straight in.

Pair it with a notched box

We drill every notched box to take part PRO600-FCLIP3D whether or not we are the ones pressing it on. Add it for $5.99 on the custom drawer box configurator and it ships installed. Built in USA, Baltic Birch or Hard Maple (Select Grade), for part PRO600-FCLIP3D.

Questions

Do you drill the box for the PRO600-FCLIP3D?

Yes, the pre bore for the PRO600-FCLIP3D is part of the free notch and drill prep on every box we cut for Würth PRO600 and PRO600 HD runners, whether we press the clip on for you or ship it loose.

Does the PRO600-FCLIP3D correct tilt?

Height, side, and depth are on the clip; the 3D and 2D Würth devices, including the PRO600-FCLIP3D, cover all three between them.